2 - 40
EAN-8/JAN-8 Extend
When this parameter is enabled, five leading zeros are added to decoded EAN-8 symbols to make them compatible in
format to EAN-13 symbols. Use parameter “Convert EAN-8 to EAN-13 Type” to label the extended symbol.
When disabled, EAN-8 symbols are transmitted as is and parameter “Convert EAN-8 to EAN-13 Type” setting is ignored.
Select an option by scanning either of the bar codes shown below.
UCC Coupon Extended Code
Note: UCC Coupon Extended Code replaces UPC/EAN Coupon Code.
The UCC Coupon Extended Code is an additional bar code adjacent to a UCC Coupon Code. To enable or disable UCC
Coupon Extended Code, scan the appropriate bar code below.
When enabled, this parameter decodes UPC-A bar codes starting with digit “5”, EAN-13 bar codes starting with digit “99”
and UPC-A/EAN-128 Coupon Codes.
UPCA, EAN-13 and EAN-128 must be enabled to scan all types of Coupon Codes.
Note: Use the Decode UPC/EAN Supplemental Redundancy parameter to control autodiscrimination of the EAN128 (right
half) of a coupon code.
Enable EAN-8/JAN-8 Zero Extend
* Disable EAN-8/JAN-8 Zero Extend
Enable UCC Coupon Extended Code
* Disable UCC Coupon Extended Code
To Next Page
Loading...
