2 - 59
NOTIS Editing
When enabled, the start and stop characters are stripped from a decoded Codabar symbol.
Set this parameter by scanning either of the bar codes shown below.
Set Lengths for Codabar
Lengths for Codabar may be set for:
• any length,
• one or two discrete lengths,
• or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains. It also includes any start
or stop characters.
See the table titled ASCII Character Equivalents.
One Discrete Length (Parameter L1)
This option decodes only those codes containing a selected length. For example, when you want to scan only Codabar
symbols containing 14 characters, scan the Codabar One Discrete Length bar code and then “1” and “4” bar codes
using the Imager Keypad Number Symbols . Default = 5.
To begin setting one discrete length, scan this Codabar One Discrete Length bar code:
Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero.
To correct an error or to change a selection, scan Cancel on the Imager Keypad Number Symbols page.
Enable NOTIS Editing
* Disable NOTIS Editing
To Next Page
Loading...
Need help?
General