Honeywell Marathon - Transmit I 2 of 5 Check Digit; Convert I 2 of 5 to EAN 13

2 - 57
Transmit I 2 of 5 Check Digit
When enabled, the check digit is transmitted with the data.
Parameter setting for “I 2 of 5 Check Digit Verification” has no effect on this parameter value.
Set this parameter by scanning either of the bar codes shown below.
Convert I 2 of 5 to EAN 13
A successful bar code conversion requires the following to be true:
• Interleaved 2 of 5 scanning is enabled.
• One of the I 2 of 5 lengths is set to 14.
• The bar code has a leading zero.
• The bar code has a valid EAN-13 check digit.
When enabled, the parameter converts a 14 character I 2 of 5 bar code into EAN-13 and transmits it to the host as EAN-13.
Set this parameter by scanning either of the bar codes shown below.
Enable Transmit I 2 of 5 Check Digit
* Disable Transmit I 2 of 5 Check Digit
Enable Convert I 2 of 5 to EAN-13
* Disable Convert I 2 of 5 to EAN-13