2 - 13
Presentation Mode Session Timeout
This parameter, and the Presentation Mode parameter, are directed toward decoders that can scan a bar code that enters
its field of view, determine a good read/bad read, then scan again.
This parameter determines how long the decoder will attempt to decode a bar code before determining if it is a good read
or a bad read.
Presentation Mode means the decoder is always On and will scan bar codes that enter its field of view. Presentation Mode
applies to Decode Mode only.
To set the duration of the attempt to decode a bar code detected in presentation mode, scan the Presentation Mode
Session Timeout bar code below. Default = 2 Seconds.
Next scan three numeric bar codes from Imager Keypad Number Symbols to select a value between 1 and 255 that
represents tenths of a second. Single digit numbers must have a leading zero.
For example, to set 0.5 seconds, scan the Presentation Mode Session Timeout bar code, then scan the 0, 0, 5 bar codes
from the section titled Imager Keypad Number Symbols. To correct an error or change the selection, scan the Cancel bar
code and try again.
Report Version
Scan the following bar code to view the version of software currently installed in the decoder. The result will be
displayed on the host device display.
To Next Page
Loading...
Need help?
General