Pag. 6 Programming Manual SERIEAM
NOTIFIER ITALIA Doc. M-160.2-AM-8000-ENG Rev A1 AM8000_manu-prog-ENG
By pressing the enter key you can access the list of point in alarm of the zone selected on the display,
through the arrow keys you can scroll the list of the devices in alarm.
Condition with Fault zone events
The following display appears when the control unit is in condition of zone faults.
Fault events are also initially displayed for zone
Through arrow keys you can scroll the list of the Zone Faults.
Through a first pressure of the enter key
you can display the list of devices with the indication of the point
name; refer to the following figure:
Device in Alarm
D = Detector
M = module
Text programmed
For this Device
Counter
for Faulty zones
Zone with Fault events
Text programmed
for this zone
To Next Page
Loading...
Need help?
General
