Honeywell NOTIFIER AM-8000 - POINTS PROGRAMMING - Detectors; Detector Type ID and Text Association

AM_8000 Programming Manual PAGINA - 15
AM8000_manu-prog-ENG Doc. M-160.2-AM-8000-ENG Rev A1 NOTIFIER ITALIA
 Programming - Points
From the Programming menu by selecting the “Points” item is displayed the following screen, where you can
manually configure each type of addressable device on field ( Detectors or Modules ).
Detectors
By selecting “DETECTORS” and by confirming the selection through the enter key
you enter the programming procedure for Addressable Sensors.
This procedure is composed of 4 programming folders (to access the folders use the arrow keys4)
The display shows by default the first device of the first line.
To select another device use the function keys “-L” “+L” ( Lines ) and “-D” “+D” ( detectors )
Detectors MAIN folder ( Type ID and Text associated with the Detector )
Protocol to use for this device
ADV = ADVANCED ( NFX serie)
CLIP= 700 SERIE
SW Type
see Type Id table above
HW Type
see Type Id table above
Name
Programmable Text for this device
Press key -L
to program a sensor of
the previous line
Press key +L
to program a sensor of
the subsequent line
Press key -D
to program the
previous sensor
Press key +D
to program the
subsequent sensor