Honeywell NOTIFIER AM-8000 - FAULT SIGNALING TIMINGS; Mains Fault Detection and TX Fault Delay; System Password Configuration; Password Levels Management

AM_8000 Programming Manual PAGINA - 13
AM8000_manu-prog-ENG Doc. M-160.2-AM-8000-ENG Rev A1 NOTIFIER ITALIA
FAULTS signalings timings folder
Press the right Arrow key4 to change the parameters to manage the Fault signallings: :
 MAINS FAULT DETECTION TIME is the minimum time during which Mains Fault is signalled if there is
no mains
 TX FAULT DELAY TIME (function not implemented)
Through the arrow keys select the item which is required to be changed (“Mains”, “Tx Faults” ) by
pressing the enter key
the editing function is activated
Through the arrow keys  data are entered and through the enter key
entered data are confirmed.


P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
-
-
S
S
y
y
s
s
t
t
e
e
m
m
-
-
P
P
a
a
s
s
s
s
w
w
o
o
r
r
d
d
This function allows to change the Password for the three access levels.
Each password consists of 5 numerical characters.
Through the arrow keys select the item which is
required to be changed.
Press the enter key
to activate the Numeric
Keyboard to program the Password.
Type the NEW password and hit Enter
Re-type and confirm the password entered.
Mains Loss
Timings are expressed in
seconds, from a minimum of
0 sec. to a max. of 300 sec.
TX Faults:
(not yet implemented)
Timings are expressed in
seconds, from a minimum of
0 sec. to a max. of 600 sec.