Honeywell NOTIFIER AM-8000 - Detector Edit and Block Programming; Remove, Copy, and Paste Detector Points

Pag. 18 Programming Manual SERIEAM
NOTIFIER ITALIA Doc. M-160.2-AM-8000-ENG Rev A1 AM8000_manu-prog-ENG
Tracking
By enabling the tracking option when the device exceeds the alarm threshold the control unit activates the following
indications.
- Output modules associated through CBE
- Buzzer
- Control unit siren output
- Alarm point indication on the display
When the point returns in normal state the output modules associated through CBE return idle, while the following
signaling are still active:
- Buzzer
- Control unit siren output
- Alarm point indication on the display
The reset procedure must be performed to clear all signaling.
Led-Blink:
By selecting “NO” in the” Led Blink” function, the flashing of the led on the sensor is disabled during the line interrogation.
This function can be used in some environments such as hospitals, hotels, etc.
D
D
e
e
t
t
e
e
c
c
t
t
o
o
r
r
E
E
D
D
I
I
T
T
f
f
o
o
l
l
d
d
e
e
r
r
(
(
c
c
o
o
m
m
m
m
o
o
n
n
f
f
o
o
r
r
a
a
l
l
l
l
s
s
e
e
n
n
s
s
o
o
r
r
s
s
w
w
h
h
i
i
c
c
h
h
a
a
l
l
l
l
o
o
w
w
s
s
t
t
o
o
r
r
e
e
m
m
o
o
v
v
e
e
a
a
n
n
d
d
c
c
o
o
p
p
y
y
p
p
o
o
i
i
n
n
t
t
s
s
f
f
r
r
o
o
m
m
…
…
t
t
o
o
…
…
)
)
This folder allows the programming of block of points sharing the same programmings
It can be used if the points have consecutive addresses and have common parameters.
The “Remove From …to” function allows to eliminate from the control unit programming an entire consecutive
block of points, by entering the start and end addresses.
The Copy and Paste functions allow the programming of the block points and can be used if the devices of the
same line have consecutive addresses and common parameters.
The procedure to perform the block programming is the following:
 Select a device from which the parameters must be copied (Type ID, CBE, etc. ).
 Perform the “Copy” control to save all the parameters of the previously selected device (with the
exception of the number of “Zone” to which “000” is assigned) , in a memory support area.
 When this operation has been performed it is signaled on the display with:
Copy L01S003