Honeywell NOTIFIER AM-8000 - Page 28

Pag. 24 Programming Manual SERIEAM
NOTIFIER ITALIA Doc. M-160.2-AM-8000-ENG Rev A1 AM8000_manu-prog-ENG
Where:
The PROT
(
Protocol
)
control can dis
p
la
y
the table of devices for one of the two
p
ossible
p
rotocols: CLIP or ADV
TYPE = Type of devices found ( see table above)
NEW = New device found
NFO = Devices previously programmed but not coherent with what was detected during the Auto-Learn
procedure
TOT
= total of devices detected on the line ( NEW + INC + correctly programmed devices.)
MAN = Devices previously programmed but not detected during the Auto-Learn
The CONF control saves the devices detected during the Self-Learn according to the following mode:
- NEW and INC are initialised through the default data.
- MAN are removed
- The correctly programmed devices keep the current programming
The data relevant to the initialized devices can be subsequently changed by entering the point programming
procedure.
Auto-Learn
Summar
y
Type NEW NFO TOT MIS
PHOT 000 000 002 000
THER 000 000 005 000
CMA1 000 000 004 000
MMA1 000 000 005 000
Sample screen for CLIP detectors.
Important Note :
On Each Line can be installed
a max number of 10 device using CLIP protocol.