Honeywell OMNI 408 - Page 35

Section 7 - System Programming
7–3
QUESTION 04
ACCOUNT NUMBER 1 DEFAULT = 1234
Enter the 3- or 4-digit subscriber account number for central station phone number 1. If a 3-digit
number is used, then enter an “A” as the fourth digit. Valid entries are 0-9, and B-F. The value “A” is
interpreted as the null value for account numbers.
QUESTION 05
ACCOUNT NUMBER 2 DEFAULT = AAAA
Enter the 3- or 4-digit subscriber account number for central station phone number 2. If a 3-digit
number is used, then enter an “A” as the fourth digit. Valid entries are 0-9, and B-F. The value “A” is
interpreted as the null value for account numbers. If the second phone number is not used, this
question can be left as factory-defaulted.
THIS ACCOUNT NUMBER MUST BE ENTERED IF YOU HAVE PROGRAMMED A SECOND
RECEIVER PHONE NUMBER FOR BACKUP, SPLIT REPORTING, OR PAGER FOLLOW-ME.
QUESTION 06 OMNI-408 DEFAULT = E011
CS DIALER OPTIONS OMNI-408EU DEFAULT = E031
There are 4 locations (L1-L4) within this question, which define various dialer and system options, as
follows:
Question 06, L1
CS Dialer Formats Default = E
Enter the digit for the desired dialer format from the table below in Location L1.
Digit
CS REPORTING
FORMAT
FORMAT
TRANSMISSION TYPE
0 3X1 Standard PULSE
1 4x1 Standard PULSE
2 3x1 Extended PULSE
* These formats require a high/low
handshake frequency from the CS receiver.
3 4x1 Extended PULSE
4 3x1 Partial Extended PULSE
5 4x1 Partial Extended PULSE
6 3x2 PULSE
For more information on CS
reporting formats, refer to Appendix
A at the back of this guide.
7 4x2 PULSE
A ADEMCO 4x2 Express * DTMF
E
Contact ID
®
*
DTMF
Question 06, L2
CS Receiver Type Default = 0
Enter the digit for the desired receiver type from the table below in Location L2.