Section 7 - System Programming
7–9
USER ON-LINE - Enables the end user command ([#] [9]) for the on-line download. This command
instructs an end user on how to initiate an on-line download, possibly preventing a service call.
BELL TEST FROM RF KEYFOBS - When set, bell test on arming/disarming (refer to Question 8,
Location 1) activates only from keyfobs. Arming/disarming from the keypad via user codes or quick
function does not trip bell test.
Audible ringback automatically occurs on all alarms except silent alarms, regardless of the
setting of this option.
USER 5 ARMS ONLY - If selected, then User 5 is used as an ARM-only code (Maid code); it does not
disarm the system.
QUESTION 08
SYSTEM TIMEOUTS DEFAULT = 665F
There are 4 locations (L1-L4) within this question, which defines various system timing options, as
follows:
Question 08, L1
Entry Delay 1 Default = 6
Enter the desired entry delay time for zones 1-3. Refer to Exit/Entry Times below for valid choices. If
zones 1-3 are delay zones, they follow Entry Delay 1. For UL applications, the maximum Entry
Delay shall not exceed 45 seconds.
NOTE: See Programming Question 09, Location 1 for Entry Delay 2.
Digit ENTRY TIMEOUTS Digit ENTRY TIMEOUTS
0 1 second 8 40 seconds
1 5 seconds 9 45 seconds
2 10 seconds A 50 seconds
3 15 seconds B 55 seconds
4 20 seconds C 1 minute
5 25 seconds D 1 minute 5 seconds
6 30 seconds E 1 minute 10 seconds
7 35 seconds F 3 minutes
Question 08, L2
Exit Delay Default = 6
Enter the desired exit time.
NOTE: For UL applications, the maximum exit delay shall not exceed 60 seconds.
To Next Page
Loading...
