Honeywell OMNI 408

To Next Page

To Previous Page

Section 7 - System Programming

7–21

QUESTION 12

ZONE 2 TYPE & CS CODE DEFAULT = 4132

Question 12, L1 & L2 - Zone 2 Type Default = 41

Question 12, L3 & L4 - CS Code for Zone 2 Default = 32

Zone 2 = Interior Follower w/CS Reporting code = 32

QUESTION 13

ZONE 3 TYPE & CS CODE DEFAULT = 1033

Question 13, L1 & L2 - Zone 3 Type Default = 10

Question 13, L3 & L4 - CS Code for Zone 3 Default = 33

Zone 3 = Instant (Perimeter) w/CS Reporting code = 33

NOTE: If zones 1 - 3 are programmed as DELAY zones, they follow ENTRY DELAY 1. If

zones 4 - 8 are programmed as DELAY zones, they follow ENTRY DELAY 2.

QUESTION 14

ZONE 4 TYPE & CS CODE DEFAULT = 1034

Question 14, L1 & L2 - Zone 4 Type Default = 10

Question 14, L3 & L4 - CS Code for Zone 4 Default = 34

Zone 4 = Instant (Perimeter) w/CS Reporting code = 34

QUESTION 15

ZONE 5 TYPE & CS CODE DEFAULT = 1035

Question 15, L1 & L2 - Zone 5 Type Default = 10

Question 15, L3 & L4 - CS Code for Zone 5 Default = 35

Zone 5 = Instant (Perimeter) w/CS Reporting code = 35

QUESTION 16

ZONE 6 TYPE & CS CODE DEFAULT = 1036

Question 16, L1 & L2 - Zone 6 Type Default = 10

Question 16, L3 & L4 - CS Code for Zone 6 Default = 36

Zone 6 = Instant (Perimeter) w/CS Reporting code = 36

QUESTION 17

ZONE 7 TYPE & CS CODE DEFAULT = 1037

Question 17, L1 & L2 - Zone 7 Type Default = 10

Question 17, L3 & L4 - CS Code for Zone 7 Default = 37

Zone 7 = Instant (Perimeter) w/CS Reporting code = 37

QUESTION 18

ZONE 8 TYPE & CS CODE DEFAULT = 1038

Question 18, L1 & L2 - Zone 8 Type Default = 10

Question 18, L3 & L4 - CS Code for Zone 8 Default = 38

Zone 8 = Instant (Perimeter) w/CS Reporting code = 38

Honeywell OMNI 408 - Page 53