EasyManua.ls Logo

Honeywell OMNI 408 - Page 54

Honeywell OMNI 408
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OMNI-408/OMNI-408EU Installation and Setup Guide
722
QUESTION 19
CS CODES for AMBUSH and AC LOSS DEFAULT = AAAA
There are 4 locations (L1-L4) in this question as follows:
Question 19, L1 & L2 - Ambush Code Default = AA
If an Ambush code is defined, User no. 6 is the Ambush code. The same rules apply here regarding
dialer format. If transmission is not desired, program AA in locations L1 and L2.
NOTE: Ambush transmissions are immediate and cannot be aborted.
Question 19, L3 & L4 - AC Loss Code Default = AA
The same rules apply here regarding dialer format. If transmission is not desired, program AA in
locations L3 and L4.
NOTE: AC loss is reported 15 minutes after detection.
QUESTION 20
CS CODES for PANIC and LOW BATTERY DEFAULT = 22AA
There are 4 locations (L1-L4) in this question:
Question 20, L1 & L2 - Panic Code Default = 22
The same rules for programming regarding dialer format apply here. If transmissions are not desired,
program AA in locations L1 and L2.
NOTE: Panic transmissions are immediate and cannot be aborted.
Question 20, L3 & L4 - Low Battery Code Default = AA
The same rules for programming regarding dialer format apply here. If transmissions are not desired,
program AA in locations L3 and L4. Low-battery transmissions are reported 4 minutes after detection.
Low-Battery Restore Code is reported within 4 minutes after detection of good battery condition.
QUESTION 21
CS CODES for OPEN/CLOSE and CS TEST DEFAULT = AAAA
There are 4 locations (L1-L4) in this question:
Question 21, L1 - Opening Code Default = A
Question 21, L2 - Closing Code Default = A
L1 is the single-digit Opening code. L2 is the single-digit Closing code. Entry of AA into these two
locations means that openings and closings are not desired. If a dialer format other than standard is
programmed, the second digit transmitted is the user number.
Question 21, L3 & L4 - CS Test Code Default = AA
L3 - L4 is the CS Test code. The CS Test code is transmitted at the interval selected in Question 09,
Location 3.
NOTE: Any digit entered is transmitted unless CS Test is disabled; to disable CS Test, see Question 09,
Location 3.

Table of Contents

Related product manuals