Section 7 - System Programming
7–23
QUESTION 22
CS CODES for BYPASS, RESTORE, TROUBLE and CANCEL DEFAULT = AAFA
There are 4 locations (L1-L4) in this question:
Question 22, L1 - Bypass Code Default = A
L1 is the single-digit system Bypass code that upon arming is reported to the central station if a zone is
bypassed. Entry of an “A” means that bypasses are not to be transmitted. If a 2-digit dialing format has
been selected, the Bypass code is followed by the programmed second digit of the Zone code.
Question 22, L2 - Restore Code Default = A
L2 is the single-digit system Restore code reported to the central station. Restores are reported for all
burglary or 24-hour zones by enabling this code (digits 0-9, B-F), and enabling zone restores in
Question 06, Location 3. Entry of an “A” means that restores are not to be transmitted. If a 2-digit
dialer format has been programmed, the Restore code is followed by the programmed second digit of the
Zone code.
NOTE: Restore is not selectable by zone.
Question 22, L3 - Trouble Code Default = F
L3 is the single-digit system Trouble code reported to the central station. This code is reported on day
trouble and fire trouble. If a 2-digit format has been programmed, this code is followed by the second
digit of the respective Zone code.
Question 22, L4 - Cancel Code Default = A
If an alarm occurs when you disarm the system, the Cancel code is sent if report is a value other than
“A.”
QUESTION 23
CS CODES for KEYPAD FIRE and KEYPAD AUXILIARY DEFAULT = AAAA
There are 4 locations (L1-L4) in this question:
Question 23, L1 & L2 - Keypad Fire Code Default = AA
L1 and L2 are the Alarm code that is transmitted upon activation of the Keypad Fire condition
(pressing the two Fire keys or the [7] [9] keys on the keypad). This code can vary from any of the zones
that are programmed as Fire.
Question 23, L3 & L4 - Keypad Auxiliary Code Default = AA
L3 and L4 are the code transmitted to the CS for Keypad Aux. condition (pressing the two Aux. keys or
[1] [3] from the keypad).
NOTE: These keypad emergency conditions are optional and can be enabled within Question 07 of the
programming sequence. If either or both of these transmissions are not desired, program their
respective locations as “AA.”
QUESTION 24
CS CODES RF LOW BATTERY & SUPERVISION DEFAULT = AAAA
There are 4 locations (L1-L4) in this question:
Question 24, L1 - RF Low Battery Code Default = A
Question 24, L2 - RF Low Battery Restore Default = A
To Next Page
Loading...
