Honeywell OMNI 408

To Next Page

To Previous Page

OMNI-408/OMNI-408EU Installation and Setup Guide

7–24

Question 24, L3 - RF Supervisory Default = A

Question 24, L4 - RF Supervisory Restore Default = A

NOTE: In any Question 24 location, if a 2-digit format has been programmed, the second digit of the

respective Zone code follows this code.

RF has not been evaluated by UL and must not be used for UL installations.

QUESTION 25

CS CODES BELL SUPERVISION & TAMPER DEFAULT = AAAA

There are 4 locations (L1-L4) in this question:

Question 25, L1 & L2 - Bell Supervision Code Default = AA

Question 25, L3 - RF Tamper Code Default = A

Question 25, L4 - RF Tamper Restore Default = A

NOTE: In any Question 25 location, if a 2-digit format has been programmed, the second digit of the

respective Zone code follows this code.

RF has not been evaluated by UL and must not be used for UL installations.

QUESTION 26

RF ZONES DEFAULT = 00A0

There are 4 locations (L1-L4) in this question:

Question 26, L1 - RF Zones 5-8 Default = 0

Question 26, L2 - RF Zones 1-4 Default = 0

L1 - RF Zones 5-8 L2 - RF Zones 1-4

RF ZONES RF ZONES

Digit

5 6 7 8

Digit

1 2 3 4

0 None 0 None (Zones 1-4 are hardwired)

9 9

9 9 9

9 9

9 9 9

9 9 9 9

Honeywell OMNI 408 - Page 56