Web Operation | 51
800-18161V1 - A - 07/2014
BLC Mode OFF Disables the BLC function. The default for BLC
is that it is disabled.
BLC The camera automatically adjusts the exposure
to suit the conditions, so that the darkest area
of the video can be seen.
WDR By lowering the brightness of the brightest
area, and enhancing the brightness of the
darkest area, WDR balances brightness and
darkness in a scene so that both the darkest
area and the lightest area can be seen clearly at
the same time.
This value ranges from 1 to 100.
Note When you switch the camera from
non-WDR to WDR mode, there might be
a few seconds lapse in video.
HLC When the HLC function is enabled, the camera
can lower the brightness of the brightest
section of video, according to the selected HLC
control level. HLC can reduce the amount of
halo and lower the brightness of the entire
video image.
This value ranges from 1 to 100. The default
value is 50 when HLC is turned on.
HLC is enabled only when Anti-flicker is set to
Outdoor, and the Exposure is set to Auto.
Mirror Click to switch the video from left to right.
This function is disabled by default.
Flip No Flip: This function is disabled by default.
Flip 180°: The video resolution needs to be set to 720p or less for the
Flip 180° function to work.
3D Noise
Reduction
3D noise reduction is enabled by default.
3D NR Level This value ranges from 0 to 100. The default is 50 when 3D NR is on.
Full-screen
Test
Click the button on the bottom left of the video window to begin
a full-screen test. Double-click to return to the normal-sized test.
Default Click to return the camera to the default setup.
Cancel Click to cancel the current operation and restore the previously saved
operation.
Save Click to save the currently configured customized settings.
Table 3-6 Camera Configurations
Parameter Function
To Next Page
Loading...
Need help?
General