Control Panel Installation
P/N 151204 3-9
3.7 AC Wiring
The Model SK-5208 power supply delivers 24 VDC at 6A for smoke detector power,
notification device power, and accessory power. Figure 3-3 shows the AC connections to the
SK-5208 control panel.
Figure 3-3 AC Wiring
Note: Note: All conduit and wiring connected to the SK-5208 must meet the applicable National Electric Code,
NFPA Standards, state, and local building code requirements. In all cases, the authority having
jurisdiction takes precedence.
Warning
To reduce the risk of electrical shock, make sure that all power has been turned off or disconnected before attempting
to connect the Model SK-5208 control panel. Do NOT apply power to this panel until all accessories are properly
connected.
To Next Page
Loading...
Need help?
General
