Model SK-5208 Fire Control/Communicator Installation and Operation Manual
5-12 P/N 151204
5.8.2 Directly Connecting to a Programming Computer
The control panel can be up or downloaded from a computer that is directly connected to the
control panel.
Note: This connection is to be used as a temporary connection and should be disconnected after programming is
completed.
To initiate communication:
1. Connect a serial cable from the control panel to the computer.
2. Make sure SKSS software is running and that the up/download task is in the queue.
3. Press the or the up arrow until the display reads Call Computer.
4. Enter the Installer Code.
The control panel will then begin the communication process with the remote computer.
To Next Page
Loading...
