Access Class Enum Value Enum Description
CAL_CMD Calibration command Uint8 1 Read/Write Dynamic
0 - None No value
1 - Cal Lower Calibrate for lower value
2 - Cal Upper Calibrate for upper value
3 - Cal Re store Restore calibration
4 - Cal Clear Clear calibration
CAL_STATUS Calibration status Uint8 1 Read Only Dynamic
0 - None No value
1 - Success Calibration successful
2 - Failed Calibrate failed
3 - Bad Factory Cal Bad factory calibration
4 - Bad User Cal Bad user calibration
5 - Internal Error Internal error
6 - Bad Units Bad units
7 - Bad Sensor Bad sensor
8 - Bad Trim Point Bad trim point
9 - Success with Excess Success with Excess
CAL_POINT_HI Cal Point High Float 4 Read/Write Static
CAL_POINT_LO Cal point low Float 4 Read/Write Static
CAL_SOURCE Calibration Source Uint8 1 Read Only Dynamic
1 - None Calibration source none
2 - User User Calibration
3 - Factory Factory Calibration
CAL_UNIT Units of calibration point Uint16 2 Read/Write Static
1001 - A°C degree Celsius
1002 - A°F degree Fahrenheit
1243 - mV millivolt
1342 - % percent
SENSOR_TYPE Describes the type of sensor. Different values for different types of AITB (Thermocouple, mV, mA, Ohm, RTD, etc) Uint8 1 Read/Write Static
ThermoCouple AITB 1 - TC-B Thermocouple B type
2 - TC-E Thermocouple E type
3 - TC-J Thermocouple J type
4 - TC-K Thermocouple K type
5 - TC-NIC Thermocouple NIC type
6 - TC-R Thermocouple R type
7 - TC-S Thermocouple S type
8 - TC-T Thermocouple T type
RTD AITB 1 - PT100 PT100 RTD Type
2 - PT200 PT200 RTD Type
3 - PT500 PT500 RTD Type
Current AITB 1 - 0 - 20 mA Zero To Twenty Milliamp Range
2 - 4 - 20mA Four To Twenty Milliamp Range
Millivolt AITB
1 - 0 - 10 mV Zero to Ten Millivolt Range
2 - 0- 50 mV Zero to Fifty Millivolt Range
3 - 0- 100 mV Zero to One Hundred Millivolt Range
Resistance AITB
1 - 0 - 100 Ohms Zero to One Hundred Ohm Range
2 - 0- 200 Ohms Zero to Two Hundred Ohm Range
3 - 0- 500 Ohms Zero to Five Hundred Ohm Range
3 - 0- 1000 Ohms Zero to One Thousand Ohm Range
PV.STATUS The Status of the Process Variable 1 Read Dynamic The Status of the Process Variable
COLD_JUNC The Value of the Cold Junction Sensor float 4 Read Dynamic Only Available on Thermocouple type AITBs
To Next Page
Loading...
