12
Fastrack Panel Configuration
4. Fastrack Panel Configuration
The fire alarm control panels are provided with a built-in Fastrack configuration utility that
is simple to use. The Fastrack process allows the basic configuration parameters to be
programmed using a simple, step-by-step approach.
The Fastrack process has the following five simple steps:
1. Initializing system and upgrading the ULD Firmware
2. Setting panel language
3. Learn peripherals
4. Learn loops
5. Panel reboot
When the panel is powered up, the LCD shows the first configuration prompt. You will be
guided through the Fastrack configuration until completion. The entire procedure takes
only a few minutes.
Throughout this process the internal buzzer activates intermittently, but this may be muted,
and the SYSTEM FAULT and FAULT LEDs are illuminated; the LEDs are extinguished upon
completion. The intermittent internal buzzer is also silenced, if this was not muted.
4.1 Fastrack Setup
Refer the following procedure for Fastrack setup:
1. Switch ON the panel, the system will initialized followed by the ULD Firmware Upgrade.
Figure 4.1 Upgrading ULD Firmware
To Next Page
Loading...
Need help?
General
