NORMAL OPERATION 
    Touchpoint Pro 
Pt. No. 2400M2566_1_EN  27  Operating Manual 
5 Normal Day-to-Day Operation 
There are several methods of interacting with TPPR: 
•  Controller Touchscreen (Supplied) 
•  PC Configuration Software (Licensed Option) 
•  Webserver (Licensed Option) 
•  Modbus (Option) 
5.1  TPPR Controller Touchscreen Interface 
The Touchscreen allows authorised users direct control of all of the TPPR functions. These functions are fully described in 
the TPPR manual suite. 
5.2  TPPR PC Configuration Software Interface 
PC Configuration software is an optional remote method for accessing the TPPR via a secure local Network connection. 
The PC Configuration tool allows an authorised remote user to configure the controller, and to remotely view or amend the 
controller configuration. 
The PC Configuration Interface is broadly similar to the Touchscreen Interface described in this manual but please refer to 
the downloadable PC Configuration User Guide for information on licensing, setup and day-to-day running. 
PC Configuration software requires the TPPR controller to be configured with a unique static IP address, which is normally 
obtained from your site IT department. 
Note: You may need Administrator privileges on the host PC. 
5.3  TPPR Webserver Interface 
The Webserver Interface is an optional remote method for accessing the TPPR display and viewing live TPPR events via an 
Ethernet connection. Events can be acknowledged and reset using the appropriate access passwords and event history can 
be analysed. Reports can be generated and saved or viewed on the host PC. 
The Webserver allows an authorised remote user to Accept and Reset events on the controller, and to Inhibit channels, or 
clear Inhibits. The controller may be configured to not allow these actions. 
The Webserver Interface is broadly similar to a limited version of the Touchscreen Interface described in this manual but 
please refer to the downloadable Webserver User Guide for information on licensing, setup and day-to-day running. 
The TPPR controller requires a static IP address for use with the Webserver, normally obtained from your site IT 
department.