What to do if I lost connection with Honeywell Control Systems controller?
If communication with the Honeywell Control Systems controller is lost, check the Touchpoint Pro Touchscreen for any instructions or detailed error messages that may indicate the cause of the interruption.
How to avoid unexpected timeout during Honeywell touchpoint Pro configuration?
To avoid unexpected timeouts during configuration on your Honeywell Control Systems, send a value to the Touchpoint Pro system within the 20-minute configuration timeout period. If a timeout occurs, you may need to reset the module to its Normal state. Go to the System Setup screen, select the module, and choose 'Set Normal state' from the Tools menu. Note that if this was a first-time configuration, all data will be deleted and the channel decommissioned. If you were editing a channel, any unsent data will be lost.
What to do if I cannot clear Inhibit from a Channel on my Honeywell touchpoint Pro Control Systems?
If you cannot clear an Inhibit from a channel on your Honeywell Control Systems, it may be because there is more than one inhibit condition active. You have to resolve all inhibit conditions before the inhibit can be cleared. Ensure all inhibits are cleared.
How to fix slow response from Honeywell Control Systems?
The Honeywell Control Systems Web Server supports up to 5 concurrent web clients. If you experience slow or intermittent responses, reduce the number of active web clients to five or fewer.
How to troubleshoot Honeywell Control Systems PC configuration SW connection?
To troubleshoot a missing PC Configuration SW connection in Honeywell Control Systems, check the IP settings and ensure proper cable connections. The PC should be connected to the Ethernet port of the Touchpoint Pro Control Module.
How to fix Honeywell Control Systems screen that does not respond to touch?
If the Honeywell Control Systems screen is unresponsive to touch, reset the Communication Board by selecting the Accept and Reset buttons together on the front panel for more than 10 seconds.
What to do if I forgot the Honeywell Control Systems admin password?
If you have lost the admin password for Honeywell Control Systems, a Honeywell authorized engineer is required to create a new Admin user. Forgotten passwords cannot be recovered.
Why does Honeywell Control Systems show 'Web browser already open' error?
The ‘Web browser already open’ error message in Honeywell Control Systems is due to an MS Windows limitation where the browser doesn't fully shut down or other instances remain open. Use Task Manager to close the browser or select CTRL+ALT+DEL>Start Task Manager>Processes>[Your browser]>End Process.
How to resolve Honeywell Control Systems CCB version mismatch?
To resolve a CCB version mismatch in Honeywell Control Systems, ensure that both CCB-M and CCB-R have the same revision level firmware.
How to resolve Honeywell Control Systems unexpected timeout during configuration?
To avoid unexpected timeouts during Honeywell Control Systems configuration, send a value to the Touchpoint Pro system within the 20-minute configuration timeout period. If a timeout occurs, set the module back to Normal state by navigating to the System Setup screen, selecting the module, and choosing 'Set Normal state' from the Tools menu.
General| Category | Control Systems |
|---|---|
| Touchscreen | Yes |
| Power Supply | 24 VDC |
| Display Type | LCD |
| Connectivity | Ethernet |
| Communication | Modbus |
| Communication Ports | RS485, Ethernet |
| Operating Temperature | 0°C to 50°C |
| Mounting | Wall mount, Panel mount |
To Next Page
