Honeywell touchpoint Pro - Page 7

CONTENTS
Touchpoint Pro
Pt. No. 2400M2566_1_EN vii Operating Manual
6.2 STEL / LTEL Alarms ......................................................................................................... 39
6.2.1 Using the STEL Alarm ................................................................................................. 39
6.2.2 Assigning the STEL Alarm to an Output Relay ............................................................ 40
6.3 Rate Alarm ........................................................................................................................ 40
6.4 Relay Activated Outputs ................................................................................................... 40
6.5 Sensor Over Range Operation.......................................................................................... 40
6.5.1 Gas Readings .............................................................................................................. 41
6.6 Sensor Over Range Operation.......................................................................................... 41
6.6.1 Gas Readings .............................................................................................................. 41
6.7 Catalytic Sensor Over Range Operation ........................................................................... 41
6.8 Full Scale Exceeded and Over Range Warning Operation ............................................... 41
6.8.1 Event Status with a Rising Gas Reading ..................................................................... 42
6.8.2 Event Status as the Gas Concentration Decreases ..................................................... 42
6.8.3 Special Considerations when using Catalytic Sensors ................................................ 43
6.8.4 Configuration of Relay Outputs .................................................................................... 43
6.9 Responding to Alarms, Faults and Warnings .................................................................... 44
6.9.1 To View Active Alarms ................................................................................................. 45
6.9.2 To Acknowledge an Active Alarm ................................................................................ 45
6.9.3 To Reset a Latched Alarm ........................................................................................... 46
6.10 Viewing Faults and Warnings............................................................................................ 46
6.10.1 To View Faults and Warnings ...................................................................................... 46
6.10.2 To Acknowledge (Accept) a Fault or Warning.............................................................. 47
6.10.3 To Reset a Latched Fault or Warning .......................................................................... 47
6.11 Inhibiting a Channel .......................................................................................................... 47
6.11.1 How to Inhibit a Channel .............................................................................................. 47
6.11.2 Channel Auto-Inhibits .................................................................................................. 48
7 Maintenance Procedures .............................................................................................................. 49
7.1 Routine Maintenance ........................................................................................................ 49
7.2 Periodic Maintenance ....................................................................................................... 50
7.2.1 Battery Enclosure Maintenance ................................................................................... 50
7.2.2 Cable Maintenance ...................................................................................................... 50
8 How to Test the TPPR System ..................................................................................................... 51
8.1 Introduction ....................................................................................................................... 51
8.2 LED Panel Test ................................................................................................................. 52
8.3 Field Inputs Test ............................................................................................................... 52
8.4 Configuration Settings Test ............................................................................................... 53
8.4.1 How to use the Configuration Settings Test Mode ....................................................... 53
8.5 Cause and Effect Test ...................................................................................................... 54
8.5.1 How to use the Cause and Effect Test Mode:.............................................................. 54
8.6 Panel Button Test ............................................................................................................. 55
8.7 System Relay Test ............................................................................................................ 55
8.8 LCD Screen Test .............................................................................................................. 56