11 - 11
Record Counter *Record Counter Off BATENT0 3-14
Record Counter On BATENT1 3-14
Total Records Total Records BATNRC 3-14
Batch Mode Output Order *FIFO BATLIF0 3-14
LIFO BATLIF1 3-14
Clear All Codes After Transmission *Don’t Clear All Codes After Transmission BATCLX0 3-14
Clear All Codes After Transmission BATCLX1 3-14
Clear All Codes Clear All Codes BATCLR 3-15
Transmit Records Automatically *Don’t Transmit Records Automatically BATATX0 3-15
Transmit Records Automatically BATATX1 3-15
Transmit Records to Host Transmit Inventory Records BAT_TX 3-15
Batch Mode Transmit Delay *Off BATDLY0 3-15
Short (ms) BATDLY250 3-15
Medium (ms) BATDLY500 3-16
Long (ms) BATDLY1000 3-16
Scanner Name Scanner Name BT_NAM 3-17
Bluetooth PIN Code Bluetooth PIN
*0000
BT_PIN 3-17
Auto Reconnect Mode *Auto Reconnect On BT_ACM1 3-17
Auto Reconnect Off BT_ACM0 3-18
Maximum Link Attempts Maximum Link Attempts
Range 0-255 (*0)
BT_MLA### 3-18
Reset Reset Base RESET_ 3-19
Reset Scanner :*:RESET_ 3-19
Cordless System Operation (Voyager 1202g-BF)
Note: This section applies only to Voyager 1202gt-BF cordless systems. It does not apply to corded scanners.
Base Power Communication Indicator *On :*:BASRED1 4-4
Off :*:BASRED0 4-4
Reset Scanner Reset Scanner RESET_ 4-4
Scanning While in Base Cradle Scanning in Cradle Off BT_SIC0 4-5
*Scanning in Cradle On BT_SIC1 4-5
Paging Mode *On BEPPGE1 4-5
Off BEPPGE0 4-5
Paging Pitch Low (*1000) (min 100Hz) BEPPFQ1000 4-5
Medium (3250) BEPPFQ3250 4-5
High (4200) (min 5000Hz) BEPPFQ4200 4-6
Scanner Address Scanner Address BT_LDA 4-6
Base Address Base Address :*:BASLDA 4-6
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page
To Next Page
Loading...
