11 - 12
Scanner Modes Charge Only Mode :*:BASLNK0 4-6
*Charge and Link Mode :*:BASLNK1 4-6
Locked Link Mode :*:BASCON0 4-7
*Open Link Mode :*:BASCON1 4-7
Unlink Scanner BT_RMV 4-7
Override Locked Scanner BT_RPL1 4-7
Out-of-Range Alarm Scanner Alarm Type BT_ORW 4-8
Scanner Alarm Duration (Range 1 - 3000
sec (*1))
BT_ORD 4-8
Auto Reconnect Mode *Auto Reconnect On BT_ACM1 4-8
Auto Reconnect Off BT_ACM0 4-8
Maximum Link Attempts Maximum Link Attempts
Range 0-255 (*0)
BT_MLA### 4-9
Reset Reset Base RESET_ 4-10
Reset Scanner :*:RESET_ 4-10
Input/Output Selections
Power Up Beeper Power Up Beeper Off - Scanner BEPPWR0 5-1
*Power Up Beeper On - Scanner BEPPWR1 5-1
Beep on BEL Character Beep on BEL On BELBEP1 5-1
*Beep on BEL Off BELBEP0 5-1
Beeper - Good Read Off BEPBEP0 5-1
*On BEPBEP1 5-1
Beeper Volume - Good Read Off BEPLVL0 5-1
Low BEPLVL1 5-2
Medium BEPLVL2 5-2
*High BEPLVL3 5-2
Beeper Pitch - Good Read
(Frequency)
Low (1600 Hz) BEPFQ11600 5-2
*Medium (2350 Hz) BEPFQ12350 5-2
High (4200 Hz) BEPFQ14200 5-2
Beeper - Transmit Order Before Transmission BEPWHN1 5-2
After Transmission BEPWHN2 5-2
Beeper Pitch - Error (Frequency) *Razz (100 Hz) BEPFQ2100 5-3
Medium (2000 Hz) BEPFQ22000 5-3
High (4200 Hz) BEPFQ24200 5-3
Beeper Duration - Good Read *Normal Beep BEPBIP0 5-3
Short Beep BEPBIP1 5-3
Number of Beeps - Good Read Range 1 - 9 (*1) BEPRPT# 5-3
Number of Beeps - Error Range 1 - 9 (*1) BEPERR# 5-4
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page
To Next Page
Loading...
