Xenon XP User Guide 119
HEALTHCARE SETTINGS
The following settings have been developed to enhance scanning in a healthcare
environment. These settings are only supported by the Xenon XP 1950h scanner
and the Xenon XP 1952h and Xenon XP 1952h-BF scanner and base. They allow
you to set quickly configure streaming presentation, and to set the scanner and
base to quiet modes for scanning that do not disturb resting patients.
Quiet Operations - Combination Codes
The following combination codes program your Xenon XP healthcare scanner and
base for silent or quiet settings using a single programming code. If you wish to
program some of these quiet settings individually, refer to Quiet Operations - LED
and Volume Settings, beginning on page 121.
Silent Mode with Flashing LED
Scan the following barcode to completely silence the scanner and base. The
scanner beep, base beep, base and scanner power up beep, and scanner linking
sounds are all silenced. When a barcode is scanned, the LED and aimer flash
5 times. Green indicates a good scan, red indicates a bad scan.
Silent Mode with Flashing LED -
Cordless Scanner and Base
Silent Mode with Flashing LED -
Corded Scanner
To Next Page
Loading...
