Honeywell Xenon XP 1952g - Chapter 2 - Program the Interface; Introduction; Program the Interface - Plug and Play; Keyboard Wedge

CHAPTER
2
Xenon XP User Guide 15
PROGRAM THE INTERFACE
Introduction
This chapter describes how to program your system for the desired interface.
Program the Interface - Plug and Play
Plug and Play barcodes provide instant scanner set up for commonly used
interfaces.
Note: After you scan one of the codes, power cycle the host terminal to have the interface in
effect.
Keyboard Wedge
If you want your system programmed for an IBM PC AT and compatibles keyboard
wedge interface with a USA keyboard, scan the barcode below. Keyboard wedge is
the default interface.
Note: The following barcode also programs a carriage return (CR) suffix.
IBM PC AT and Compatibles with
CR suffix