Honeywell Xenon XP 1952g - Code 93

Xenon XP User Guide 161
When Check Digit is set to Validate and Transmit, the scanner only reads
Interleaved 2 of 5 barcodes printed with a check digit, and will transmit this digit at
the end of the scanned data. Default = No Check Digit.
Interleaved 2 of 5 Message Length
Scan the barcodes below to change the message length. Refer to Message Length
Description (page 154) for additional information. Minimum and Maximum
lengths = 2-80. Minimum Default = 6, Maximum Default = 80.
FEBRABAN Decode
Scan the barcodes below to turn FEBRABAN Boleto decoding on or off. Default =
Off.
* No Check Digit
Validate, but Don’t Transmit
Validate and Transmit
Minimum Message Length
Maximum Message Length
FEBRABAN Decode On
*FEBRABAN Decode Off