Honeywell Xtralis FAAST FLEX FLX-020

FAAST FLEX Product Guide FAASTFLEX
11 www.xtralis.com
3.4 Orientation
The FAAST FLEX can be mounted either in standard orientation or inverted (see Figure3-5). The access and
location of the inlet and outlet pipes is usually the determining factor in selecting the orientation.
Note: Inverted installation must be set using dip-switch 9.
9 10 9 10
STANDARD MOUNTING
AIR INLETS
DIP
SWITCH
SETTING
DIP SWITCH
SETTING
INVERTED MOUNTING
AIR INLETS
AIR OUTLET
AIR OUTLET
Figure3-5: Mounting Orientation
3.5 Front Label
The device is shipped with the front panel labels installed for standard mounting. The labels are double-sided;
one side is printed for standard mounting, and the reverse side is printed for inverted mounting (see
Figure3-6). The label should be installed to match the mounting orientation. To place the label, detach the 4
gray clips from inside the cover and snap the retainers off the device. Position the label as desired, then snap
the retainer back in place.
Note: Inverted installation must be set using dip-switch 9.
Figure3-6: Front Label Installation