Need help?Do you have a question about the Honeywell Xtralis FAAST FLEX FLX-020 and is the answer not in the manual?
General| Model | FLX-020 |
|---|---|
| Type | Aspirating Smoke Detector |
| Technology | Laser-based detection |
| Detection Method/Principle | Light scattering |
| Power Supply | 24 VDC |
| Communication Interface | RS-485 |
| Enclosure Rating | IP30 |
| Sensitivity Range | 0.001% to 20% obscuration per meter |
| Humidity | 10% to 95% RH, non-condensing |
| Fault Outputs | 1 Relay |
| Communication Protocol | Modbus RTU |
| Weight | 1.5 kg |
| Approvals | EN 54-20 |
Refers to graphical instructions for mounting and connecting the unit.
Instructions on how to mount the FAAST FLEX unit on a flat surface.
Guidelines for connecting inlet and exhaust piping to the detector.
Details on using adapters for 25mm piping and outlet piping connections.
General considerations for wiring the FAAST FLEX detector.
Steps for entering the six-digit passcode to access protected functions.
Procedure for changing the device's security passcode.
How to perform a self-test on the device and confirm results.
Steps to recover a lost passcode via USB and email.
Procedure to reset the device to default EEPROM factory settings.
Step-by-step guide for replacing the sensing module.
Instructions for replacing the air inlet and outlet filters.
Parameters and rules for designing I-pipe networks for single channel units.
Parameters and rules for designing U-pipe networks for single channel units.
Parameters and rules for designing I-pipe networks for dual channel units.
Parameters and rules for designing U-pipe networks for dual channel units.
Example calculation for an I-pipe network design.
Example calculation for a U-pipe network design.
To Next Page