Memory module
1. Prepare the computer for disassembly (see Preparation for disassembly on page 14).
2. Remove the stand assembly (see Stand assembly on page 15).
3. Remove the display (see Display on page 16).
4. Spread the two retention clips outward (1) until the memory module tilts up at a 45-degree angle.
5. Grasp the edge of the memory module (2), and then gently pull the module out of the slot. Use the same
procedure to remove both memory modules.
CAUTION: To prevent damage to the memory module, hold the memory module by the edges only. Do
not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
Reverse this procedure to install a memory module.
IMPORTANT: Memory modules are in a stacked conīguration. If only one module is installed it must be in
the bottom memory socket.
Memory module 21
To Next Page
Loading...
Need help?
General
