EasyManuals Logo

HP 200 G3 User Manual

HP 200 G3
105 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
Computer Setup—Power
NOTE: Support for specic Computer Setup options may vary depending on the hardware conguration.
Option Description
OS Power Management
Runtime Power Management— Enable/Disable. Allows certain operating systems to reduce
processor voltage and frequency when the current software load does not require the full
capabilities of the processor. Default is enabled.
Idle Power Savings—Extended/Normal. Allows certain operating systems to decrease the
processors power consumption when the processor is idle. Default is extended.
Hardware Power
Management
SATA Power Management – Enables or disables SATA bus and/or device power management. Default is
enabled.
Thermal CPU Fan Speed—Display current fan speed.
Computer Setup—Advanced
NOTE: Support for specic Computer Setup options may vary depending on the hardware conguration.
Option Heading
Power-On Options Allows you to set:
POST messages (enable/disable). Enabling this feature will cause the system to display POST error
messages, which are error messages displayed on the monitor during the Power On Self Test if the
BIOS encounters some kind of problem while starting the PC. A POST error message will only display
on screen if the computer is capable of booting this far. If the POST detects an error before this
point, a beep code is generated instead. Default is disabled.
After Power Loss (o/on/previous state). Default is Power o. Setting this option to:
Power o—causes the computer to remain powered o when power is restored.
Power on—causes the computer to power on automatically as soon as power is restored.
Previous state—causes the computer to power on automatically as soon as power is restored,
if it was on when power was lost.
NOTE: If you turn o power to the computer using the switch on a power strip, you will not be able to
use the suspend/sleep feature or the Remote Management features.
POST Delay (in seconds). Enabling this feature will add a user-specied delay to the POST process.
This delay is sometimes needed for hard disks on some PCI cards that spin up very slowly, so slowly
that they are not ready to boot by the time POST is nished. The POST delay also gives you more
time to select F10 to enter Computer (F10) Setup. Default is None.
Remote Wakeup Boot Source (remote server/local hard drive). Default is Local hard drive.
BIOS Power-On Allows you to set the computer to turn on automatically at a time you specify.
Bus Options Allows you to enable or disable:
PCI SERR# Generation. Default is enabled.
PCI VGA Palette Snooping, which sets the VGA palette snooping bit in PCI conguration space; only
needed when more than one graphics controller is installed. Default is disabled.
Device Options Allows you to set:
Num Lock State at Power-On (o/on). Default is o.
Multi-Processor (enable/disable). Default is enabled.
42 Chapter 5 Computer Setup (F10) Utility

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 200 G3 and is the answer not in the manual?

HP 200 G3 Specifications

General IconGeneral
Memory TypeDDR4
ProcessorIntel Core i3/i5/i7
Storage500 GB HDD; 128 GB SSD
Operating SystemWindows 10 Pro
PortsUSB 2.0, HDMI, VGA, Ethernet, Audio

Related product manuals