HP 3000 9x9KS - Power Requirements; Table 2-2. Power Requirements

To Next Page

To Previous Page

2-6

Power Requirements

The most important installation considerations are for power requirements. The basic power

requirements for the HP 3000 and HP 9000 Enterprise Servers are listed in Table 2-2. (Additional

power specifications are contained in Appendix B of this manual.) Also, refer to Section 3 of the

Computer Products Site Preparation Resource Guide. Your Hewlett-Packard Sales Representative and

CE can assist you in determining peripheral power requirements.

NOTE

Some systems require single-phase power. Single-phase power may be

obtained by making power connections in one of the following ways:

• Line-to-neutral: 200-240 Volts (One hot (phase) wire and a neutral).

• Line-to-line: 200-240 Volts. Connect across two phase (hot) wires.

i. 20 Amps for: HP 9000 Models K100, K200, K210, K220, K400, K410, & K420 and HP 3000

Models 929KS, 939KS, 959KS, 969KS/x00, and 969KS/x20

Table 2-2. Power Requirements.

Line Voltage 90-127 VAC or

200-240 VAC

(Nominal)

Line Frequency 50-60 Hz ±5%

Voltage Waveform Harmonic

Distortion

<5%

Recommended Circuit

Breaker Rating

30 Amps

(motor start rating)

Other manuals for HP 3000 9x9KS