HP 3600 v2 Series Security Configuration Guide

90
To do… Use the command… Remarks
Enter system view system-view —
Configure EAP relay or EAP
termination
dot1x authentication-method
{ chap | eap | pap }
Optional
By default, the network access
device performs EAP termination
and uses CHAP to communicate
with the RADIUS server.
Specify the eap keyword to enable
EAP termination.
Specify the chap or pap keyword
to enable CHAP-enabled or
PAP-enabled EAP relay.
NOTE:
If EAP relay mode is used, the user-name-format command configured in RADIUS scheme view does no
t
take effect. The access device sends the authentication data from the client to the server without any
modification. For more information about the user-name-format command, see
Security Command
Reference
.
Setting the port authorization state
The port authorization state determines whether the client is granted access to the network. You can
control the authorization state of a port by using the dot1x port-control command and the following
keywords:
• authorized-force—Places the port in the authorized state, enabling users on the port to access the
network without authentication.
• unauthorized-force—Places the port in the unauthorized state, denying any access requests from
users on the port.
• auto—Places the port initially in the unauthorized state to allow only EAPOL packets to pass, and
after a user passes authentication, sets the port in the authorized state to allow access to the network.
You can use this option in most scenarios.
You can set authorization state for one port in Ethernet interface view, or for multiple ports in system view.
If different authorization state is set for a port in system view and Etherent interface view, the one set later
takes effect.
Follow these steps to set the authorization state of a port:
To do… Use the command… Remarks
Enter system view system-view —
Set the port
authorization
state
In system view
dot1x port-control { authorized-force |
auto | unauthorized-force } [ interface
interface-list ]
Optional
Use either approach.
By default, auto applies.
In Ethernet
interface view
interface interface-type interface-number
dot1x port-control { authorized-force |
auto | unauthorized-force }

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English