155
Follow these steps to configure the portal user information synchronization function:
To do… Use the command…
Remarks
Enter system view system-view —
Configure the portal user
information synchronization
function
portal server server-name user-sync
[ interval interval ] [ retry retries ]
Required
Not configured by default.
The portal server specified in the
command must exist. This function
can take effect only when the
specified portal server is
referenced on the interface
connecting the users.
NOTE:
• The user information synchronization function requires that a portal server supports the portal user
heartbeat function. Only the iMC portal server supports the portal user heartbeat function. To implemen
the portal user synchronization function, you also need to confi
ure the user heartbeat function on the
portal server and make sure that the product of interval and retry is
reater than or equal to the portal
user heartbeat interval. HP recommends configuring the interval to be greater than the portal user
heartbeat interval configured on the portal server.
• For redundant user information on the device—information for users who are considered nonexistent on
the portal server, the device deletes the information durin
the (N+1)th interval, where N is equal to the
value of
retries
configured in the portal server user-sync command.
Logging off portal users
Logging off a user terminates the authentication process for the user or removes the user from the
authenticated users list.
Follow these steps to log off users:
To do… Use the command…
Remarks
Enter system view system-view —
Log off users
portal delete-user { ip-address | all
| interface interface-type
interface-number }
Required
Displaying and maintaining portal
To do… Use the command… Remarks
Display the ACLs on an interface
display portal acl { all | dynamic |
static } interface interface-type
interface-number [ | { begin |
exclude | include }
regular-expression ]
Available in any view
To Next Page
Loading...
Need help?
General