EasyManuals Logo
Home>HP>Switch>3600 v2 Series

HP 3600 v2 Series Security Configuration Guide

HP 3600 v2 Series
398 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #281 background imageLoading...
Page #281 background image
270
# Create an IPsec policy named policy001, specify the manual mode for it, and configure the SPIs of the
inbound and outbound SAs to 123456, and the keys for the inbound and outbound SAs using ESP to
abcdefg.
[SwitchC] ipsec policy policy001 10 manual
[SwitchC-ipsec-policy-manual-policy001-10] proposal tran1
[SwitchC-ipsec-policy-manual-policy001-10] sa spi outbound esp 123456
[SwitchC-ipsec-policy-manual-policy001-10] sa spi inbound esp 123456
[SwitchC-ipsec-policy-manual-policy001-10] sa string-key outbound esp abcdefg
[SwitchC-ipsec-policy-manual-policy001-10] sa string-key inbound esp abcdefg
[SwitchC-ipsec-policy-manual-policy001-10] quit
# Apply IPsec policy policy001 to the RIPng process.
[SwitchC] ripng 1
[SwitchC-ripng-1] enable ipsec-policy policy001
[SwitchC-ripng-1] quit
4. Verify the configuration
After the configuration, Switch A, Switch B, and Switch C learns IPv6 routing information through RIPng.
SAs are set up successfully, and the IPsec tunnel between two peers is up for protecting the RIPng packets.
Using the display ripng command on Switch A, you will see the running status and configuration
information of the specified RIPng process. The output shows that IPsec policy policy001 is applied to this
process successfully.
<SwitchA> display ripng 1
RIPng process : 1
Preference : 100
Checkzero : Enabled
Default Cost : 0
Maximum number of balanced paths : 8
Update time : 30 sec(s) Timeout time : 180 sec(s)
Suppress time : 120 sec(s) Garbage-Collect time : 120 sec(s)
Number of periodic updates sent : 186
Number of trigger updates sent : 1
IPsec policy name: policy001, SPI: 123456
Using the display ipsec sa command on Switch A, you will see the information about the inbound and
outbound SAs.
<SwitchA> display ipsec sa
===============================
Protocol: RIPng
===============================
-----------------------------
IPsec policy name: "policy001"
sequence number: 10
mode: manual
-----------------------------
connection id: 1
encapsulation mode: transport
perfect forward secrecy:

Table of Contents

Other manuals for HP 3600 v2 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 3600 v2 Series and is the answer not in the manual?

HP 3600 v2 Series Specifications

General IconGeneral
BrandHP
Model3600 v2 Series
CategorySwitch
LanguageEnglish

Related product manuals