HP 3600 v2 Series

286
NOTE:
During SSH server configuration, the client public key is required. Use the client software to
g
enerate RS
A
key pairs on the client before configuring the SSH server.
1. Configure the SSH client.
# Generate the RSA key pairs.
Run PuTTYGen.exe, select SSH-2 RSA and click Generate.
Figure 105 Generate a key pair on the client 1)
When the generator is generating the key pair, you must move the mouse continuously and keep the
mouse off the green progress bar shown in Figure 106. Other
wise, the progress bar stops moving and
the key pair generating process will be stopped.