HP 5120 EI Series

51

8. Set bootrom password recovery

9. Set switch startup mode

0. Reboot

Enter your choice(0-9):

Enter 0 at the prompt. The system reboots in full startup mode and displays the following information:

Starting......

********************************************************************************

* *

* HP 5120-24G-PoE+ EI TAA Switch with 2 Interface Slots BOOTROM, Version 205 *

* *

********************************************************************************

Creation date : Feb 23 2011, 09:36:58

CPU Clock Speed : 264MHz

BUS Clock Speed : 33MHz

Memory Size : 128MB

Mac Address : 3ce5a62f8dde

Press Ctrl-B to enter Boot Menu... 5

In full startup mode, you must press Ctrl + B within five seconds to access the Boot menu. If you perform

no operation or press any key other than Ctrl + B within five seconds, the system automatically starts up

and displays the following information:

Auto-booting...

Decompress Image................................................................

................................................................................

..............OK!

Board checking.......................LSP1LTSUD

SDRAM fast selftest........................OK!

Flash fast selftest........................OK!

CPLD selftest..............................OK!

Switch chip selftest.......................OK!

PHY selftest...............................OK!

Please check leds....................FINISHED!

Other manuals for HP 5120 EI Series