To erase the waveform display
•
Press
Erase
.
Acquisition memory and the current display are immediately erased. If the
instrument is in Run or Autostore mode, however, and the oscilloscope finds
a trigger condition, the display will be quickly updated after the erasure.
Summary of Oscilloscope Storage Keys
Run—acquires data and displays the most recent trace.
Stop—freezes the display.
Single—acquires a single trace.
Autostore—acquires data, displaying the most recent trace in full-bright and
previously acquired waveforms in half-bright.
Erase—clears the display.
Run/Stop/Single/Autostore/Erase Operation
To erase the waveform display
4-38
To Next Page
Loading...
