To make voltage measurements automatically
You can measure the following voltage parameters automatically with the
oscilloscope: peak-to-peak, average, rms, maximum, minimum, top, base,
amplitude, overshoot, and preshoot. The following exercise guides you
through the Voltage keys by making an rms voltage measurement. Steps for
making other voltage measurements are included at the end of the
procedure. The following figures show pulses with some of the voltage
measurement points.
Pulse with Well-Defined Top and Bottom
Pulse with Top and Bottom not Well-Defined
Figure 5-25
Figure 5-26
Making Measurements with HP 54645A/D Oscilloscopes
To make voltage measurements automatically
5-32
To Next Page
Loading...
