Removing and Replacing Assemblies
Refer to the exploded view of the oscilloscope in this chapter for
details on how the oscilloscope fits together. To install an assembly,
follow the instructions in reverse order.
You will need the following tools to disassemble the oscilloscope:
• T15 TORX driver to remove the oscilloscope from the cabinet and
to remove the fan.
• T10 TORX driver to remove the assemblies from the deck.
• Flat-blade screwdriver to remove the front panel and power shaft
and the optional interface modules and pouch.
You can remove any of the following assemblies: fan, front panel,
display, system board, power supply, keyboard, and handle.
8-3
To Next Page
Loading...
