Table 4-1
HP 54645A Factory-Preset Default Configuration Settings
Configuration Item Setting
Cursors Cursors off; time readout is selected; all cursors are set to time/voltage zero.
Trace memories Both trace memory 1 and 2 are off; trace 1 memory is selected.
Graticule Grid set to Full
Autostore Off
Time base Time reference center; main, not delayed sweep; vernier off; main and delay value 0;
100
µ
s/div main time base; 500 ns/div delayed time base; sample rate is 200 MSa/s.
Display Vectors On, Display Mode Normal.
Channels Channel 1 on, Position 0 V, Volts/Div 100 mV.
Trigger Mode Auto Level, Coupling DC, Reject Off, Noise Reject Off.
Trigger Condition Rising edge of channel 1
Saving and Recalling the Configuration
To reset the HP 54645A/D instrument setup
4-49
To Next Page
Loading...
