24
Put away the removed power supply in an antistatic bag or the power supply package bag for
future use.
5. Install the filler module to prevent dust and ensure proper ventilation if no power supply is installed
in the slot.
Figure 34 Removing the power supply
The switch provides one filler module for the power supply slot. To prevent dust and ensure good
ventilation, promptly install a filler module for an empty power supply slot. To do so, slide the filler
module slowly along the guide rails into the slot until you hear that the latch of the filler module clicks into
the slot, as shown in Figure 35.
IMPORTANT:
hen you install a filler module, make sure the blade of the flathead screwdriver si
n on the filler module
points upwards.
1
2
To Next Page
Loading...
Need help?
General
