HP 5800 Series Configuration Guide

149
[IRF] interface GigabitEthernet 3/0/3
[IRF-GigabitEthernet3/0/3] port link-aggregation group 3
[IRF-GigabitEthernet3/0/3] quit
2. Configuration on Switch A
# Create dynamic aggregate interface 1.
<SwitchA> system-view
[SwitchA] interface bridge-aggregation 1
[SwitchA-Bridge-Aggregation1] link-aggregation mode dynamic
[SwitchA-Bridge-Aggregation1] quit
#Add ports GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 that connect
to IRF member switches to aggregation group 1 (corresponding to aggregate interface 1).
[SwitchA] interface GigabitEthernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] port link-aggregation group 1
[SwitchA-GigabitEthernet1/0/1] quit
[SwitchA] interface GigabitEthernet 1/0/2
[SwitchA-GigabitEthernet1/0/2] port link-aggregation group 1
[SwitchA-GigabitEthernet1/0/2] quit
[SwitchA] interface GigabitEthernet 1/0/3
[SwitchA-GigabitEthernet1/0/3] port link-aggregation group 1
[SwitchA-GigabitEthernet1/0/3] quit
3. Configuration on Switch B
# Create dynamic aggregate interface 2.
<SwitchB> system-view
[SwitchB] interface bridge-aggregation 2
[SwitchB-Bridge-Aggregation2] link-aggregation mode dynamic
[SwitchB-Bridge-Aggregation2] quit
#Add ports GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 that connect
to IRF member switches to aggregation group 2 (corresponding to aggregate interface 2).
[SwitchB] interface GigabitEthernet 1/0/1
[SwitchB-GigabitEthernet1/0/1] port link-aggregation group 2
[SwitchB-GigabitEthernet1/0/1] quit
[SwitchB] interface GigabitEthernet 1/0/2
[SwitchB-GigabitEthernet1/0/2] port link-aggregation group 2
[SwitchB-GigabitEthernet1/0/2] quit
[SwitchB] interface GigabitEthernet 1/0/3
[SwitchB-GigabitEthernet1/0/3] port link-aggregation group 2
[SwitchB-GigabitEthernet1/0/3] quit
4. Configuration on Switch C
# Create dynamic aggregate interface 3.
<SwitchC> system-view
[SwitchC] interface bridge-aggregation 3
[SwitchC-Bridge-Aggregation3] link-aggregation mode dynamic
[SwitchB-Bridge-Aggregation3] quit

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)