HP 5800 Series Configuration Guide

10
Configuring the history buffer size
To configure the history buffer size:
Ste
p
Command Remarks
Enter system view system-view —
Enter user interface view
user-interface { first-num1
[ last-num1 ] | { aux | vty }
first-num2 [ last-num2 ] }
—
Set the maximum number of
commands that can be saved in the
history buffer
history-command max-size
size-value
Optional
By default, the history buffer can
save up to 10 commands.
NOTE:
For more information about user-interface and history-command max-size, see “Logging in to the switch
commands.”
Controlling the CLI display
Multi-screen display
Controlling multi-screen display
If the output information spans multiple screens, each screen pauses after it is displayed. Perform one of the
following operations to proceed.
Action Function
Press Space Displays the next screen.
Press Enter Displays the next line.
Press Ctrl+C Stops the display and the command execution.
Press <PageUp> Displays the previous page.
Press <PageDown> Displays the next page.
By default, each screen displays up to 24 lines. To change the maximum number of lines displayed on the
next screen, use screen-length. For more information about screen-length, see “Logging in to the switch
commands.”

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)