HP 5800 Series Configuration Guide

55
password on the remote authentication server. For more information about authentication modes and
parameters, see Security Configuration Guide. Keep your username and password.
The following table lists modem login configurations for different authentication modes:
Authentication
mode
Configuration Remarks
None Configure not to authenticate users.
For more information, see
“Configuring none
authentication for modem
login.”
Password
Configure the device to authenticate users by using the
local password.
For more information, see
“Configuring password
authentication for modem
login.”
Set the local password.
Scheme
Configure the authentication scheme.
For more information, see
“Configuring scheme
authentication for modem
login.”
Select an
authentic
ation
scheme.
Remote AAA
authentication
Configure a
RADIUS/HWTACAC
S scheme.
Configure the AAA
scheme used by the
domain.
Configure the
username and
password on the AAA
server.
Local authentication
Configure the
authentication
username and
password.
Configure the AAA
scheme used by the
domain as local.
NOTE:
Modem login authentication changes do not take effect until you exit the CLI and log in again.
Configuring none authentication for modem login
Prerequisites
You have logged in to the device.
By default, log in to the device through the console port without authentication and have user privilege level
3 after login. For information about logging in to the device with the default configuration, see
“Configuration requirements.”

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)