HP 5800 Series Configuration Guide

44
Figure 13 Configuration page
Configuring common settings for VTY user interfaces (optional)
CAUTION:
The auto-execute command command may disable you from configuring the system through the user
interface to which the command is applied. Use it with caution.
Before executing the auto-execute command command and saving the configuration (by using save). Be
sure you can access the device through VTY and AUX user interfaces so you can remove the confi
g
uration
w
hen a problem occurs.
Ste
p
Command Remarks
1. Enter system view. system-view —
2. Enable display of copyright
information.
copyright-info
enable
Optional.
Enabled by default.
3. Create a VLAN interface and enter
VLAN interface view.
interface vlan-
interface vlan-
interface-id
Required.
If the VLAN interface already exists, the
command enters the VLAN interface view.
4. Specify an IP address for a VLAN
interface.
ip address ip-
address { mask |
mask-length }
Required.
By default, no IP address is specified for a
VLAN interface.
5. Return to system view.
quit —
6. Enter one or multiple VTY user
interface views.
user-interface vty
first-number
[ last-number ]
—

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)