HP 5800 Series Configuration Guide

1
Configuring the CLI
CLI enables you to interact with your device by typing text commands. At the CLI, instruct your device to
perform a given task by typing a text command and then pressing Enter. Compared with the graphical user
interface (GUI) where you can use a mouse to perform configurations, the CLI allows you to enter more
information in one command line.
Figure 1 CLI example
Entering the CLI
HP devices provide multiple methods for entering the CLI, such as through the console port, through Telnet,
or through SSH. For more information, see “Login methods.”

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)