EasyManuals Logo

HP 5800 Series Configuration Guide

HP 5800 Series
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
46
Configuring the device to log in to a Telnet server as a Telnet
client
Prerequisites
You have logged in to the device.
By default, log in to the device through the console port without authentication and have user privilege level
3 after login. For information about logging in to the device with the default configuration, see
Configuration requirements.”
Figure 14 Log in to anot
her device from the current device
NOTE:
If the Telnet client port and the Telnet server port that connect them are not in the same subnet, make sure
that the two devices can reach each other.
Procedure
Follow the step below to configure the device to log in to a Telnet server as a Telnet client:
Ste
p
Command
Remarks
1. Configure the device to log in to a
Telnet server as a Telnet client.
telnet remote-host [ service-port ]
[ [ vpn-instance vpn-instance-name ] |
[ source { interface interface-type
interface-number | ip ip-address } ] ]
Required.
Use either command.
Available in user view.
telnet ipv6 remote-host [ -i
interface-type interface-number ]
[ port-number ] [ vpn-instance
vpn-instance-name ]
2. Specify the source IPv4 address or
source interface for sending Telnet
packets.
telnet client source { interface
interface-type interface-number | ip
ip-address }
Optional.
By, no source IPv4
address or source
interface is specified. The
source IPv4 address is
selected by routing.

Table of Contents

Other manuals for HP 5800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5800 Series and is the answer not in the manual?

HP 5800 Series Specifications

General IconGeneral
MAC Address Table Size32, 000 entries
Uplink Ports2 or 4 SFP+ 10GbE ports
Routing ProtocolBGP, IS-IS
Input Voltage100-240 VAC
Operating Temperature0°C to 45°C
Operating Humidity10% to 95% (noncondensing)
PoEOptional
Power SupplyRedundant power supply (optional)

Related product manuals