HP 5800 Series Configuration Guide

29
The following table lists console port login configurations for different authentication modes:
Authenticat
ion mode
Configuration Remarks
None Configure not to authenticate users.
For more information, see
“Configuring none authentication for
console login.”
Password
Configure the device to authenticate users by using the
local password.
For more information, see
“Configuring password
authentication fo
r console login.”
Set the local password.
Scheme
Configure the authentication scheme.
For more information, see
“Configuring scheme authentication
for console login.”
Select an
authentication
scheme.
Remote AAA
authentication
Configure
RADIUS/
HWTACACS
scheme.
Configure AAA
scheme used by
the domain.
Configure
username and
password on the
AAA server.
Local
authentication
Configure
authentication
username and
password.
Configure AAA
scheme used by
the domain as
local.
NOTE:
A
newly confi
g
ured authentication mode does not take effect unless you exit and enter the CLI again.
Configuring none authentication for console login
Prerequisites
You have logged in to the device.
By default, log in to the device through the console port without authentication and have user privilege level
3 after login. For information about logging in to the device with the default configuration, see
“Configuration requirements.”

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)